Produk yang pernah dilihat
DISCONTINUED The IC-F1000D/F2000D can...
The IC-F1000D/F2000D can program Type-D single- site trunking and digital conventional modes as well as analog mode per channel.
Perhatian: produk terakhir
The IC-F1000D/F2000D can program Type-D single- site trunking and digital conventional modes as well as analog mode per channel. The IDAS digital mode employs 4-level FSK modulation and the NXDN™ common air interface, offering true 6.25kHz spectrum efficiency, higher security and better audio clarity – even at the fringes of the communication range.
The following IDAS features are programmable:
To assist in worker safety, the IC-F1000D/F2000D has three emergency related functions: motion detection, man down and lone worker functions. If one of these functions are activated, the transceiver automatically enters an emergency phase and starts counting down to send an emergency signal. The built-in motion sensor detects its position and states motion and non-motion.
While the body is compact, the IC-F1000D/ F2000D has rugged construction providing superior protection against water (1m depth for 30 minutes), dust, sand, mud and other objects. The radio is also tested to MIL-STD 810 specifications. It can withstand harsh use.
The IC-F1000D/F2000D has a compact 52.2×111.8×30.3mm body and weighs only 260g (with BP-280 battery pack and belt clip). It’s easy to carry around anywhere.
With the optional GPS speaker-microphone, HM-171GPW, GPS position data can be attached to a voice or data transmission such as responding a GPS request status call.
The large 36mm speaker of the transceiver provides clear 800mW* audio. The built-in BTL amplifier increases the audio output power and delivers loud and intelligible voice to a radio operator working in noisy environments.
*Typical with internal speaker.
The IC-F1000D/F2000D has built-in 2-Tone, 5-Tone, CTCSS and DTCS signaling capability for analog mode group communication and selective calling. The IC-F1000D/F2000D can be used as an analog transceiver ready for future digital migration.
The large capacity waterproof battery pack, BP-280 (2400mAh typ.), provides 18 hours of operating time*. The supplied rapid charger BC-213* charges the BP-280 in 3.5 hours.
*Tx: Rx: Standby=5:5:90. Power save function ON. BC-213 may be not supplied depending on version.
|Frequency coverage (MHz)||
|Number of channels||
|Type of emissions||
|Power supply requirement||7.5V DC nominal|
RX Max. auidio/ Sandby
|Operating temperature range||-30°C to 60°C; –22°F to +140°F (radio specifications)|
(Projections not included)
|52.2×111.8×30.3 mm; 2.06×4.4×1.19 in (With BP-280)|
|Weight||260g; 9.17oz (With MB-133 and BP-280)|
|Max. frequency deviation||± 5.0kHz/±2.5kHz (Wide/Narrow)|
|Spurious emissions||70dB min.|
|FM hum and noise||
|Audio harmonic distortion||
|FSK error||5.0% max.|
|Ext. microphone connector||3-conductor 2.5 (d) mm (1⁄10")⁄2.2kΩ|
(at 12dB SINAD)
(at 5% BER)
|Adjacent channel selectivity||
|Spurious response||80dB min.|
|Hum and noise||
|Ext. speaker connector||2-conductor 3.5 (d) mm (1⁄8″)/8Ω|
|Audio output power (at 5% distortion)
Internal SP (w/12Ω load)
External SP (w/8Ω load)
800mW typ. (at 5% distortion)
400mW typ. (at 5% distortion)
Measurements made in accordance with TIA-603.
All stated specifications are subject to change without notice or obligation.
* 25kHz bandwidth is no longer available for FCC Part 90 licensees for USA versions.
Ask your dealer if you need 25kHz bandwidth.
Icom makes rugged products that meet MIL-STD requirements and strict environmental standards as follows.
|Standard||MIL 810 F|
|Low Pressure||500.5||I, II|
|High Temp.||501.5||I, II|
|Low Temp.||502.5||I, II|
|Rain Blowing/Drip||506.5||I, III|
Also meets equivalent MIL-STD-810-C, -D, -E and -F.
|Ingress Protection Standard|
|Dust & Water||IP67 (Dust-tight and waterproof protection)|